Menu
The usage of composite materials has been increasing globally in all manufacturing industries. Nontraditional machining methods like electric discharge machining, ultrasonic machining, etc are used to accomplish better results in the machining of composite materials. In the present work, an attempt is made to study the study the effect of Wire Electric Discharge Machining (WEDM) parameters like pulse-on time, pulse-off time and peak current on Material Removal Rate(MRR) in Aluminum Composites. Experimentation was conducted in a series of tests using response surface methodology, in which changes are made in the input variables in order to identify the reasons for changes in the output response.
1.Huang J.T &Liao.Y.S, “Optimization of machining parameters of Wire-EDM based on Grey relational and statistical analyses” in j. prod. res., vol. 41, no. 8, 1707-1720. 2003.
2.MahadaviNejad.R “Modelling and Optimization of Electrical Discharge Machining of SiC Parameters, Using Neural Network and Non-dominating Sorting Genetic Algorithm (NSGA II)”Scientific Research, pp 669-675. 2011
3.Yang R.T, Tzeng.C.J, Yang Y.K & Hsieh M.H “Optimization of wire electrical discharge machining process parameters for cutting tungsten” Int J AdvManufTechnol 60: pp 135-147, 2012.
4.Malik M, Yadav R.K, Kumar N, Sharma D&Manoj “optimization of process parameters of Wire-EDM using zinc-coated brass wire” International Journal of Advanced Technology & Engineering Research, Volume 2, issue 4 july, 2012.
5.Boopathi S &Sivakumar K “Experimental investigation and parameter optimization of near-dry wire-cut electrical discharge machining using multi-objective evolutionary algorithm” Int J AdvManufTechnol 67: pp 2639-2655,2013.
6.Majumder A “Process parameter optimization during EDM of AISI 316 LN stainless steel by using fuzzy based multi-objective PSO”, Journal of Mechanical Science and Technology 27 ( 7) ,pp 2143-2151. 2013.
7.Phipon R & Pradhan S.S “Process Parameters Optimization Of Micro Electric Discharge Machining Process Using Genetic Algorithm” International Journal of Engineering Research and Applications. Vol. 2, Issue 5, pp.1986-1993. September- October 2012.
8.Rajyalakshmi G &VenkataRamaiah P “Multiple process parameter optimization of wire electrical discharge machining on Inconel 825 using Taguchi grey relational analysis” Int J AdvManuf Techno1.2013.
9.Kumara K &Ravikumar R “Optimization of WEDM parameters using Taguchi design to check surface roughness” International Journal of Modern Engineering Research, Vol. 3, Issue. 3, pp-1645-164.8, May.-June. 2013.
10.Tosun N, Cogun C &Inan A “The Effect of Cutting Parameters on Work-piece Surface Roughness in Wire EDM”, MACHINING SCIENCE AND TECHNOLOGY, Vol. 7, No. 2,. pp. 209-219, 2003.
11.cayda U, Hascalik A& Ekici S “An adaptive neuro-fuzzy inference system (ANFIS) model for wire EDM” Expert Systems with Applications 36 pp:6135-6139,2009.
Desh Bhagat University,
Off to NH-44, Amloh Road, Mandi Gobindgarh,
District Fatehgarh Sahib, Punjab- 147301, India